For remote drilling in metal, the 4270-20 is a great choice. The entire tool weighs just 26-1/2 pounds and has a comfortable carrying handle well positioned for balance, with cutter wrenches stored on-board. This is a very portable machine. However, power was not sacrificed for portability. This drill press includes a very powerful 1.1 maximum horsepower, 9.0 amp motor. It can drill up to 1-1/2 in. diameter holes through 2 in. thick steel with annular cutters, or 1/2 in. diameter holes 4-1/4 in. deep with twist drill bits. The tool is setup to accept standard 3/4 in. Weldon shank cutters, or an optional 3-jaw chuck is available for use with twist drill bits. The strong two-coil magnet provides 2,300 lbs. of deadlift force on 1 in. thick steel. The simple two-button control panel is located on the back, away from feed handle obstruction. The feed handle can be conveniently relocated to the opposite side without the use of tools. Mag Drill Press Small,Powerful 9.0 amp 1.1 max HP motor ,Light weight only 26.5 lbs. with comfortable carrying handle ,Capacity to cut up to 1-1/2 in. diameter holes thru 2 in. steel with annular cutters or 1/2 in. diameter holes 4-1/4 in. deep with twist drill bits ,Strong two-coil magnet ,Two positions for feed handle - relocate without tools ,Simple two-button control panel - unobstructed by feed handle , ,Voltage 120 AC ,Amps 9.0 ,Drill Capacity 1/2 in. ,No Load Speed 450 RPM ,Cord Type 8 ft. Fixed ,Construction Type Grounded ,Electronic Feedback Yes ,Drill Point Pressure 750 lbs. ,Adjustable Base No ,Drill Travel 6.6 in. ,Chuck or Taper Weldon ,Tool Weight 26.5 lbs. ,INCLUDES ,Lubricant Spray Bottle ,Nylon Safety Strap ,Two Hex Wrenches